Hardware and Engineering DF6-340-... Frequency ... - Moeller.com.tr

01/02 AWB8230-1413GB Analog outputs – AM, AMI <strong>and</strong>FMAnalog outputs – AM, AMI <strong>and</strong> FMThe analog outputs provide various physical variables, which youcan select <strong>and</strong> some of which you can adjust to meet your specificneeds. Terminals AM, AMI <strong>and</strong> FM are connected to chassisthrough terminal L.Voltage output (AM)The AM terminal provides the variables listed in the table below inthe form of a 0 to 10 V voltage signal.X In PNU C028, specify the variable which the AM terminal is toprovide.X In PNU B080, specify the gain factor <strong>and</strong> in PNU C086 theoffset.You cannot change all parameters in RUN mode. Editableparameters in RUN mode are marked with a “j” in the “normal”column of the table below. With PNU b031, you can set additionalparameters which are editable in RUN mode (a section“Software protection (SFT)”, page 81). These additionalparameters are marked “j” in the “Extended” column.Adjustable in RUN modeNormal– jExtendedPNU Function Adjustable in RUN mode Value Function WENormalExtendedb080C028C086Gain, AMterminalOutput, AMterminalOffset, AMterminalj j 0 to 255 Gain of the voltage output 180– j 00 Output frequency: 0 Hz to end frequency PNU A004(a section “End frequency”, page 108)01 Output current: 0 to 200 %04 Output voltage: 0 to 100 %05 Inverter input power: 0 to 200 %06 Thermal load ratio: 0 to 100 %07 Ramp frequency: 0 Hz to end frequency PNU A004(a section “End frequency”, page 108)j j 0 to 10 V Voltage increase 0.00057