Operating Instruction - Frequency Inverter 230V / 400V ... - opis.cz

14.3 Digital OutputsThe OP. Mode Digital Output 1 530 and the relay output with the parameter Op.Mode Digital Output 3 532 link the digital outputs to various functions. The selectionof the functions depends on the parameterized configuration. The use of the multifunctionaloutput MFO1 as a digital output demands selection of an Operation Mode550 and linking via parameter Digital Operation 554.Operation modeFunction0 - Off Digital output is switched offFrequency inverter is initialized and on stand-by1 - Ready or Standby Signalor in operationController release signal and a start command are2 - Run Signalpresent, output frequency availableMessage is displayed via the parameter Current3 - Error SignalError 259 or Warnings 269.The Stator Frequency 210 is higher than the4 - Setting Frequencyparameterized Setting Frequency 510Reference Frequency The Actual Frequency 241 of the drive has5 -reachedreached the Internal Reference Frequency 228.Reference Percentage The Actual Percentage Value 230 has reached6 -Reachedthe Reference Percentage Value 229.The Warning Limit Short-Term Ixt 405 or WarningLimit Long-Term Ixt 406 has been reached.7 - Ixt warning8 - WarningMax. heat sink temperature T K of 80 °C minus theHeat sink temperature Warning Limit Heat Sink Temp. 407 reached.9 - WarningMax. inside temperature T i of 65 °C minus theInside temperature Warning Limit Inside Temperature 408 reached.Warning behavior according to parameterized10 - Warning Motor Temperature Motor Temp. Operation Mode 570 at max. motortemperature T PTC .The message is displayed via parameter Warnings11 - Warning General269.The selected limit values Warning Limit Heat SinkTemp. 407, Warning Limit Inside Temp 408 or12 - Warning over temperaturethe maximum motor temperature have been exceeded.Failure of the mains voltage and power regulation13 - Mains Failureactive according to Operation Mode 670 for thevoltage controller.Warning Motor Protect. Parameterized Operation Mode 571 for the motor14 -Switchprotection switch has triggered.A controller or the Operation Mode 573 of the15 - Warning Current Limitationintelligent current limits limit the output current.Controller Current Limit. The overload reserve for 60 s has been used up16 -Long Term Ixtand the output current is being limited.Controller Current Limit. The overload reserve for 1 s has been used up17 -Short Term Ixtand the output current is being limited.Max. heat sink temperature TK reached, intelligentcurrent limits of Operation Mode 573 active.18 - Controller Current Limit. TKController Current Limit. Max. motor temperature reached, intelligent currentlimits of Operation Mode 573 active.19 -Motor Temp.The comparison according to the selected OP.20 - Comparator 1mode Comparator 1,540 is true.Table "Operation Modes for Digital Outputs" continued on next page.02/06 123