Operating Instruction - Frequency Inverter 230V / 400V ... - opis.cz

The following table shows the assignment of the parameters to the individual logicmodules:Module Operation mode Input 1 Input 2Logic module 1 Operation Mode Input 1 Logic 1 199Logic 1 198Input 2 Logic 1 200Logic module 2 Operation Mode Input 1 Logic 2 202Logic 2 201Input 2 Logic 2 203Logic module 3 Operation Mode Input 1 Logic 3 206Logic 3 205Input 2 Logic 3, 207Logic module 4 Operation Mode Input 1 Logic 4 504Logic 4 503Input 2 Logic 4 505The parameters Operation Mode Logic 1 198, Operation Mode Logic 2 201, OperationMode Logic 3 205 and Operation Mode Logic 4 503 include the following functions:Operation modeFunction0 - Off Signal output is switched offInput 1 and input 2 are linked to each other via a logic AND1 - ANDoperation.Input 1 and input 2 are linked to each other via a logic OR2 - ORoperation.Input 1 and input 2 are linked to each other via a logic ExclusiveOR operation. Output Q will be logic "1" only if different3 - XORlogic levels are present at input 1 and input 2.Input 1 is the set input,input 2 is the reset input of the RS flip-flop.Logic "1" at the set input will set output Q to "1". Logic "1" at10 - RS Flip-Flopthe reset input will set output Q to "0".If logic "0" is present at both inputs, the output signal is keptat the last status.The output signal changes with the positive edge of the clock20 - Toggle Flip-Flop signal at input 1.Input 2 is wired internally in this configuration.If a positive clock edge is received at input 2 (clock pulse30 - D Flip-Flop input C), the signal present at input 1 (data input D) istransmitted to output Q.138 02/06