Operating Instruction - Frequency Inverter 230V / 400V ... - opis.cz

5.7 Optional ComponentsThanks to the modular hardware components, the frequency inverters can be integratedin the automation concept easily. The standard and optional modules are recognizedduring the initialization, and the controller functionality is adjusted automatically.For the information required for installation and handling of the optional modules,refer to the corresponding documentation.Danger!The hardware modules at slots B and C may only be assembled and disassembledafter the frequency inverter has been disconnected safely frompower supply. Wait for some minutes until the DC link capacitors havedischarged before starting the work.• The unit may only be connected with the power supply switched off.• Make sure that the frequency inverter is discharged.Hardware modulesA Control Unit KP500Connection of the optional control unit KP500 or an interfaceadapter KP232.BCAB Communication module CMPlug-in section for connection to various communication protocols:− CM-232: RS232 interface1 CM-485: RS485 interface2 CM-PDP: Profibus-DP interface3 CM-CAN: CANopen interfaceC Expansion module EMSlot for customer-specific adaptation of the control inputsand outputs to various applications:4 EM-ENC: extended speed sensor evaluation5 EM-RES: resolver evaluation6 EM-IO: analog and digital inputs and outputs7 EM-SYS: system-bus(system bus in combination with CM-CAN communicationmodule upon request)Attention!If two optional components with CAN-Protocol controller are installed,the system-bus interface in the EM expansion module is deactivated!48 02/06