Operating Instruction - Frequency Inverter 230V / 400V ... - opis.cz

6.5 Copy Menu (CPY)With the copy function of the control unit you can copy the parameter values from thefrequency inverter to a non-volatile memory of the control unit (upload) and store(download) them to a frequency inverter again.The copy function makes the parameterization of recurring applications much easier.The function archives all parameter values, regardless of access control and valuerange. The memory space available in the control unit for the files is dynamicallyscaled to match the scope of the data.Note:The Copy Menu (CPY) is accessible in control level 3. The control levelcan be adjusted, if necessary, via parameter Control Level 28.6.5.1 Reading the Stored InformationWhen you open the CPY menu branch, the data stored in thecontrol unit are read out. This process takes a few seconds.During this time, init and a progress indicator are displayed.After the initialization in the copy menu, the function can beselected.If the information stored in the control unit is not valid, theinitialization is stopped and an error message is displayed.In this case, the memory in the control unit must be formattedas follows:• Use the ENT key to confirm the error message.• Use the arrow keys to select the function FOr.• Use the ENT key to confirm the selection.During the formatting operation, FCOPY and a progressindicator are displayed.The process takes a few seconds. When the process iscomplete, the message rdY is displayed.• Confirm the message by pressing the ENT key.Now, you can select the copy function as described in the following.6.5.2 Menu StructureThe copy menu CPY contains three main functions. Use the arrow keys to select therequired function. Select the source and the destination for the process. The memoryspace available in the non-volatile memory of the control unit is displayed on thethree-digit seven-segment display.Function – FOrUse the function FOr to format and delete the memory in thecontrol unit. This may be necessary if a new control unit isused for the first time.Function – ALLAll readable and writable parameter values are transferred.• Confirm this selection by pressing the ENT key and continueby selecting the source.02/06 53