Sepam - HV/MV Protection and control units (ENG) - Trinet

Use – commissioningSepam 2000 identificationSepam identificationusing the pocket terminalAbout SepamSFT2800Program logicCommunicationMenu: About SepamEnterSFT28006XRS05FA CATSFT2800 98.02About SepamSFT2800Program logicCommunicationapplication typeConfiguratorversion no.6 = Sepam S36XR = modelS05 = typeF = FrenchA = rev. levelCAT = standardconfigurationEnterIn the event of a cartridge error or incompatibilitySepam 2000, the message CARTRIDGE appearson the front of the device.Check the coherence between the cartridge andSepam 2000 using the compatibility list givenon the next page.Program Logic161SFA CAT LDRAPPLICATIONSUBSTATIONProgram Logicprogram date :97/12/01 15:08LOGIPAM : 98.02CommunicationJ bus : V 3.0program logic diagram referCAT : standard program logic (1)LDR : the "source" file is loaded in the cartridge (1)name of program diagramproduced by LOGIPAMprogram logic programming dateconfigurator versionJbus communication version 3.0Others messages:- FIP ISIS- FIP I/O- Communication not installedpress menu key(1)remark: labelsLDR and NOL labels: these labels refer to thepresence or absence of a “source” file visiblewith the “Logipam” software package.NOL: the program logic “source” file is not includedin the cartridge.LDR: the “source” file has been changed in thecartridge and therefore cannnot be reinitialized (2)using a PC, equipped with the LOGIPAM softwarepackage and the PER2901 programming device.CAT: this label signifies that the standard programlogic is factory-set. When this label is not present,the logic in the Sepam has been customized.(2)the “reuse” operation is described in the LOGIPAMprogramming manual.2/44 Installation - Use - General characteristics - Testing