Sepam - HV/MV Protection and control units (ENG) - Trinet

InstallationAssembly and wiring (cont’d)Sepam 2000 S46 componentsIdentification of board slots in Sepamslot1 2 3 4 5 6 7 8 9 10 11 12 13 14S46 RR CE40 — — SBW STOR STOR STOR ETOR ETOR ETOR ETOR ETOR ETOR ETORS46 XR CE40 ECM 3V+V SBW STOR STOR STOR ETOR ETOR ETOR ETOR ETOR ETOR ETORS46 NR CE40 EANA — SBW STOR STOR STOR ETOR ETOR ETOR ETOR ETOR ETOR ETORS46 ZR CE40 EANA SONDE SBW STOR STOR STOR ETOR ETOR ETOR ETOR ETOR ETOR ETORoptional modulesConnectionsThe Sepam 2000 connections are made using theremovable connectors located on the rear of thedevice. All the connectors are screw-lockable.Wiring of screw connectors:c recommended cable fitting:v Telemecanique DZ5CE0155 for 1.5 mm 2 ,v DZ5CE0253 for 2.5 mm 2 .Stripped length with fitting: 17 mm.Without fitting:c stripped length: 10 to 12 mm,c maximum of 2 wires per terminal.The 21-pin connectors, should be pluggedin correctly by hand, above locked by the 2screws provided (top/bottom).Terminal identificationprincipleAll the Sepam 2000 connection terminals are locatedon the rear of the device.On the rear panel, the boards that make up theSepam 2000 S46 are fitted into the slots numbered1 to 14.Connections are identified by adding differentmarkings:v slot (1 to 14),v connector A or B,v terminal (1 to 21).Example: 4 A16, slot no. 4, connector A, terminal 16.7 6 5 4 3 2 1STOR STOR STOR SBW 3U/Vo3V+VECM212019181716151413121110987654321212019181716151413121110987654321212019181716151413121110987654321A87654321ASW1BSW2SW1B654321A4321ACE40+B24-30 48-125 220-250V-DC1/8 Installation - Use - Sheets