Sepam - HV/MV Protection and control units (ENG) - Trinet

Use – commissioningPasswordUse of the passwordc at the end of the sequence, the following window is displayed:The user enters a password via the pocket terminalin order to be able to change parameters and settings.Code keyWhen the user presses the code key, the followingmenu appears:Validate settingsYes = EnterNo = ClearEnter yourpassword thenpress enter keyc presser enter: the new password is validated.Please note:If the passwords entered for "new" and "verif" are different, the followingmeassage is displayed:type the following on the keyboard6543210 (1) and then press enter.This the password for standard Sepams.If your Sepam has been customized,refer to the documentation provided by your OEM.To exit from this mode, simply:c press the code keyc wait 2 min after activating any key.When the pocket terminal is in parameter settingmode, P\ appears on the top left of the screen.Modification of the passwordc go to parameter setting modec in the Status menu, choose the password headingusing the arrow and press enter.The following window is displayed:PASSWORDold =new =verif. =new passwordnot validpress "clear"Loss of the passwordIf the original password has been modified and the latest password entered hasbeen permanently lost by the user, the only means of regaining access tomodification of parameters and settings is to reprogram the cartridge using a PCequipped with the LOGIPAM software package, the PER2901 programmerand the Sepam program logic “source” file (regarding the “source” file,see the section on Sepam 2000 identification using the pocket terminal).N.B. Before reprogramming the cartridge, it is advisable to make a completerecord of the values set in the Sepam as well as the identification information.This operation may be carried out using the TSM 2001 pocket terminal,SFT 2801 software package or SFT 2821 software package (upload).In case of difficulties, contact the Schneider after-sales department.(1)Code by default in standard program logic; with customization, the password is givenby the installer.(2)4 to 7 digits are necessary.c enter, one after the other- the password to be modified in the "old" line (2)- the new password in the "new" and "verif" lines- after each password, press enter to go to the nextlineN.B. If you do not want your operating personnelto know the password that gives access to theparameter setting mode, remove this page fromthe user's documentation.2/48 Installation - Use - General characteristics - Testing