Sepam - HV/MV Protection and control units (ENG) - Trinet

InstallationChecking prior to commissioningChecksESTOR ESB ECMDECMDCE40These operations should be carried out beforeSepam 2000 is energized.Supply voltageEnsure that the cubicle auxiliary power supply hasthe same operating voltage as Sepam 2000.It is indicated on the rear of the device,beside the power supply connector, by a dot in the boxcorresponding to voltage.EarthingCheck that the Sepam 2000 chassis is earthed by thegrounding nut situated on the side panel of Sepam,on the power supply side. Check that the screw hasbeen tightened.21201918171615141312111098765432124-30 48-125 220-250V-DCA21201918171615141312111098765432124-30 48-125 220-250AV-DCBSW2SW1654321BABSW2SW1654321BA4321A+B24-30 48-125 220-250V-DC(optioncommunication)87654321INPUTS ANDOUTPUTSINPUTS ANDOUTPUTSSECONDARYCURRENTINPUTSPRIMARYCURRENTINPUTSPOWER SUPPLYCartridgeCheck that the cartridge is in its slot behind the dooron the front of the device. To do so:c Open the door by pulling on the notch situatedon the left side. On the right side of the frontof the Sepam S35, there is a shield that resembles thememory cartridge door. This shield is not another door,do not try to open it,c Check that the cartridge is pushed in,c Check, by hand, that the 2 threaded screws havebeen tightened. Never insert or remove the cartridgewhen Sepam 2000 is energized.There is an identification label on the front of thememory cartridge.The last 3 characters of the first line on the labelindicate the type of Sepam 2000 (the typecorresponds to the protection and metering functionsthat are included). Make sure that the type matchesthe Sepam model indicated on the side panel of thedevice.ConnectorsCheck that all the connectors on the rear of thedevice are correctly plugged in and screw-locked.MERLIN GERINS35 CR D023 CR D02 FA102 D FAMERLIN GERINSEPAM 2035S35 CR9346013 C08J11 TBNExample: S35 CR on the cartridge label should match S35 CR on the chassis label.Installation1/13