Contents

Parameter
Number
S1-23
S1-24
S1-25
S1-26
S1-27
Name
Display
Torque compensation
gain during
lowering
TorqCompgain@low
Torque compensation
bias during
raising
TorqComp-
Bias@ri
Torque compensation
bias during
lowering
TorqComp-
Bias@red
Dwell speed
reference
DWELL speed
Door zone speed
level
Door Zone Level
Description
Sets the torque compensation gain
at lowering when the torque compensation
at start function is used.
Sets the torque compensation bias
at raising when the torque compensation
at start function is used.
Sets the torque compensation bias
at lowering when the torque compensation
at start function is used.
Hold speed reference when the
load is heavy.The frequency reference
follows the C1-07 acceleration
4 setting time.
Acceleration time will be changed
when the motor speed exceeds the
C1-11 setting frequency.
Sets the door zone speed level.
If the motor speed (in CLV and
OLV) or the output frequency (in
V/f control) falls below S1-27
and a multifunction output is set
for the “Door zone” signal
(H2-=42), this output will be
closed.
Setting
Range
0.500
to
10.000
-200.0
to
+200.0
-200.0
to
+200.0
0.0
to 120.0
0.0
to 120.0
Factory
Setting
Control Methods
V/f
Open
Loop
Vector
Closed
Loop
Vector
Change
during
Operation
MEMO-
BUS
Register
Page
1.000 No No No A 6AAH 5-11
0.0% No No No A 6ABH 5-11
0.0% No No No A 6ACH 5-11
0.0Hz No A A A 6ADH 5-18
0.0Hz No A A A 6ADH 5-49
4-42