Contents

User Parameter Tables
Setting
Value
Function
Control Methods
14
f ref /f set agree 2 (ON: Output frequency = L4-03, with detection width L4-04 is used, and during
frequency agree)
Yes Yes Yes 5-23
15 Frequency detection 3 (ON: Output frequency ≤ -L4-03, detection width L4-04 is used) Yes Yes Yes 5-23
16 Frequency detection 4 (ON: Output frequency ≥ -L4-03, detection width L4-04 is used) Yes Yes Yes 5-23
17 Car stuck/undertorque detection 1 NC (NC Contact, OFF: Torque detection) Yes Yes Yes 5-34
18 Car stuck/undertorque detection 2 NO (NO Contact, ON: Torque detection) Yes Yes Yes 5-34
19 Car stuck/undertorque detection 2 NC (NC Contact, OFF: Torque detection) Yes Yes Yes 5-34
1A During reverse run (ON: During reverse run) Yes Yes Yes 5-48
1B During baseblock 2 (OFF: During baseblock) Yes Yes Yes 5-48
1D During regenerative operation No No Yes 5-49
1E Restart enabled (ON: Automativ fault restart enabled) Yes Yes Yes -
1F Motor overload (OL1, including OH3) pre-alarm (ON: 90% or more of the detection level) Yes Yes Yes 5-38
20 Inverter overheat (OH) pre-alarm (ON: Temperature exceeds L8-02 setting) Yes Yes Yes 5-40
30 During torque limit (current limit) (ON: During torque limit) Yes Yes Yes 5-37
31 During speed limit No No Yes 5-23
33 Zero-servo end (ON: Zero-Servo completed) No No Yes -
37
During run 2 (ON: Frequency output, OFF: Base block, DC injection braking, initial excitation,
operation stop)
Yes Yes Yes 5-47
38 During cooling fan operation Yes Yes Yes -
40 Brake Release Command Yes Yes Yes 5-11
41 Output Contactor Cloase Command Yes Yes Yes 5-11
42 Speed detection at deceleration (Door zone) Yes Yes Yes 5-49
43 Not Zero Speed Yes Yes Yes 5-49
V/f
Open
loop
Vector
Closed
Loop
Vector
Page
4
4-27