Contents

•Storing Inverter set values in the Digital Operator/Monitor (READ)
To store Inverter set values in the Digital Operator/Monitor use the following method.
Table 5.1 READ Function Procedure
Step
No.
Explanation
Digital Operator/Monitor Display
1 Press the Menu Key and select advanced programming mode.
-ADV-
** Main Menu **
Programming
2 Press the DATA/ENTER Key.
-ADV-
Initialization
A1 - 00=1
Select Language
3
Press the Increment and Decrement Key until parameter o3-01 is displayed (Copy Function
Selection).
-ADVo3
- 01=0
COPY Function
Copy Funtion Sel
4 Press the DATA/ENTER Key and select the constants setting display.
-ADV-
Copy Function Sel
o3-01= 0 *0*
COPY SELECT
5 Change the set value to 1 using the Increment Key.
-ADV-
Copy Function Sel
o3-01= 1 *0*
INV OP READ
6 Set the changed data using the DATA/ENTER Key. The READ function will start.
INV OP READING
7 If the READ function ends normally, “End” is displayed on the Digital Operator/Monitor.
-ADV-
READ
-ADV-
READ
READ COMPLETE
8 The display returns to o3-01 when a key is pressed.
-ADV-
Copy Function Sel
o3 - 01=0 *0*
COPY SELECT
If an error is displayed, press any key to cancel the error display and return to the o3-01 display. Refer to
page 6-14, Digital Operator Copy Function Faults for corrective actions.
5-60