Contents

•Comparing Inverter Parameters and Digital Operator/Monitor Parameter Set Values
(VERIFY)
To compare Inverter parameters and Digital Operator/Monitor parameter set values, use the following
method.
Table 5.3 VERIFY Function Procedure
Step
No.
Explanation
Digital Operator/Monitor Display
1 Press the MENU Key and select advanced programming mode.
-ADV-
** Main Menu **
Programming
2 Press the DATA/ENTER Key.
-ADV-
Initialization
A1 - 00 = 1
Select Language
3
Press the Increment and Decrement Key until the parameter o3-01 is displayed (Copy Function
Selection).
-ADVo3
- 01=0
COPY Function
Copy Funtion Sel
4 Press the DATA/ENTER Key and select the function setting display.
-ADVo3-01=
0 *0*
Copy Function Sel
COPY SELECT
5 Change the set value to 3 using the Increment Key.
-ADVo3-01=
3 *0*
Copy Funtion Sel
OP INV VERIFY
6 Set the changed data using the DATA/ENTER Key. The VERIFY function will start.
-ADV-
VERIFY
DATA VERIFYING
7 If the VERIFY function ends normally, “End” is displayed on the Digital Operator/Monitor.
-ADV-
VERIFY
VERIFY COMPLETE
8 The display returns to o3-01 when a key is pressed.
-ADV-
Copy Function Sel
o3 - 01 = 0 *0*
COPY SELECT
If an error is displayed, press any key to cancel the error display and return to the o3-01 display. Refer to
page 6-14, Digital Operator Copy Function Faults for corrective actions.
•Application Precautions
INFO
When using the copy function, check that the following settings are the same between the Inverter data and the Digital
• Operator/Monitor data.
• Inverter product and type
• Software number
• Inverter capacity and voltage class
• Control method
5-62