Contents

User Constants
Table 9.7 User Constants
No.
Name
Factory
Setting
S1-05 DC injection braking time at stop 0.60
Setting
S1-06 Brake release delay time 0.20
S1-07 Brake close delay time 0.10
S1-14 SE2 detection delay time 200ms
S1-15 SE3 detection delay time 200ms
S1-16 Run delay time 0.10sec
S1-17 DC injection current gain at regenerative operation 100%
S1-18 DC injection current gain at motoring operation 20%
S1-19 Output contactor open delay time 0.10sec
S1-20 Zero servo gain 5
S1-21 Zero servo completion width 10
S1-22 Starting torque compensation increase time 500ms
S1-23 Torque compensation gain during lowering 1.000
S1-24 Torque compensation bias during raising 0.0%
S1-25 Torque compensation bias during lowering 0.0%
9
S1-26 Dwell speed at start reference 0.0Hz
S1-27 Door zone speed level 0.0Hz
S2-01 Motor rated speed 1380 rpm
S2-02 Slip compensation gain in motoring mode 0.7
S2-03 Slip compensation gain in regenerative mode 1.0
S2-07 Slip compensation delay time 200ms
S3-01 Short floor operation selection 0
T1-01 Autotuning mode selection 0
T1-02 Motor output power *1
T1-03 Motor rated voltage *1
T1-04 Motor rated current *1
T1-05 Motor base frequency 60.0 Hz
T1-06 Number of motor poles 4 poles
T1-07 Motor base speed 1450 r/min
T1-08 Number of PG pulses 1024
T1-09 Motor no-load current E2-03 value
* The factory setting depends on the inverter model and the control method.
9-11