Contents

Digital Operator JVOP-160
Inverter Modes
The Inverter's parameters and monitoring functions are organized in five groups that make it easier to read and
adjust parameters.
The 5 modes and their primary functions are shown in the Table 3.18.
Table 3.18 Modes
Drive mode
Mode
Quick programming mode
Advanced programming mode
Verify mode
Autotuning mode*
* Always perform autotuning with the motor before operating in the vector control modes.
Primary function(s)
Use this mode to start/stop the inverter, to monitor values such as the frequency references
or output current and for displaying fault information or the fault history.
Use this mode to read and set the basic parameters.
Use this mode to reference and set all parameters.
Use this mode to read/set parameters that have been changed from their factory-set
values.
Use this mode when running a motor with unknown motor data in the vector control
modes. The motor data are measured/calculated and set automatically.
This mode can also be used to measure only the motor line-to-line resistance.
3
3-5