Contents

Switching Modes
The mode selection display will appear when the MENU key is pressed. Press the MENU key from the mode
selection display to switch through the modes in sequence.
Press the DATA/ENTER key to enter a mode and to switch from a monitor display to the setting display.
Display During Run
-DRIVE-
Rdy
Frequency Ref
U1- 01=50.00Hz
U1-02=50.00Hz
U1-03=10.05A
Mode Selection
Display
MENU
Monitor Display
Setting Display
-DRIVE-
** Main Menu **
Operation
ESC
-DRIVE-
Rdy
Monitor
U1 - 01=50.00Hz
U1-02=50.00Hz
U1-03=10.05A
RESET
-DRIVE-
Rdy
Frequency Ref
U1- 01=50.00Hz
U1-02=50.00Hz
U1-03=10.05A
MENU
-QUICK-
** Main Menu **
Quick Setting
ESC
-QUICK-
Control Method
A1-02 = 0 *0*
V/f Control
"0"
ESC
-QUICK-
Control Method
A1-02 = 0 *0*
V/f Control
"0"
MENU
-ADV-
** Main Menu **
Programming
-ADV-
Initialization
A1 - 00=0
Select Language
RESET
-ADV-
Select Language
A1-00 = 0 *0*
English
"0"
ESC ESC ESC
-ADV-
Select Language
A1-00 = 0 *0*
English
"0"
MENU
-VERIFY-
** Main Menu **
Modified Consts
-VERIFY-
None Modified
The constant number will be displayed if a
constant has been changed. Press the
DATA/ENTER key to enable the change.
ESC
MENU
-A.TUNE-
** Main Menu **
Auto-Tuning
ESC
-A.TUNE-
-A.TUNE-
Tuning Mode Sel
Tuning Mode Sel
T1- 01 = 0 *0* T1- 01= 0 *0*
Standard Tuning
"0"
ESC
Standard Tuning
"0"
Fig 3.24 Mode Transitions
To run the inverter after viewing/changing parameters press the MENU key and the DATA/ENTER key in sequence to
enter the Drive mode. A Run command is not accepted as long as the drive is in any other mode.
To enable Run commands from the terminals during programming set parameter b1-08 to “1”.
3-6