Quartus II Settings File Reference Manual - Altera

Chapter 9: Assembler Assignments 9–37
USE_CHECKSUM_AS_USERCODE
USE_CHECKSUM_AS_USERCODE
Type
Sets the JTAG user code to match the checksum value of the device programming file.
The programming file is a Programmer Object File (.pof) for non-volatile devices,
such as MAX II devices, or an SRAM Object File (.sof) for SRAM-based devices. If you
turn this option on, the JTAG user code option is not available.
Boolean
Device Support
This setting can be used in projects targeting the following device families:
■ Arria GX
■ Arria II GX
■ Arria II GZ
■ Arria V
■ Cyclone
■ Cyclone II
■ Cyclone III
■ Cyclone III LS
■ Cyclone IV E
■ Cyclone IV GX
■ Cyclone V
■ HardCopy III
■ HardCopy IV
■ MAX II
■ MAX V
■ Stratix
■ Stratix GX
■ Stratix II
■ Stratix II GX
■ Stratix III
■ Stratix IV
■ Stratix V
Notes
This assignment is included in the Fitter report.
June 2012 Altera Corporation Quartus Settings File
Reference Manual