Quartus II Settings File Reference Manual - Altera

Chapter 6: Fitter Assignments 6–227
OUTPUT_ENABLE_DELAY
OUTPUT_ENABLE_DELAY
Type
Specifies the propagation delay to the output enable pin from internal logic or the
output enable register implemented in an I/O cell. This is an advanced option that
should be used only after you have compiled a project, checked the I/O timing, and
determined that the timing is unsatisfactory. For detailed information on how to use
this option, refer to the data sheet for the device family. This option is ignored if it is
applied to anything other than an output pin or bidirectional pin.
Integer
Device Support
This setting can be used in projects targeting the following device families:
■ Arria GX
■ Arria II GX
■ Cyclone III
■ Cyclone III LS
■ Cyclone IV E
■ Cyclone IV GX
■ HardCopy II
■ Stratix II
■ Stratix II GX
Notes
This assignment supports wildcards.
Syntax
set_instance_assignment -name OUTPUT_ENABLE_DELAY -to -entity
June 2012 Altera Corporation Quartus Settings File
Reference Manual