molded case circuit breakers - Eaton Canada

PRL1 AND PRL2 PANELBOARDS
Originally a Westinghouse Product
Neutral Bar
REPLACEMENT CAPABILITIES
March 2001
PRL1 Without Trim PRL2 With Trim
Box Dead Front
Cover
PRL1 and PRL2
The Aftermarket Center in Sumter, SC
offers a wide variety of Cutler-Hammer
parts to support its installed base of panelboards
and switchboards.
The parts available include:
● Panelboard Connector Kits
● Breaker Mounting Hardware
● Breaker Plug-in Units and Retrofit Kits
● Trims and Covers
● Lugs and Lug Landing Kits
● Neutral and Ground Bars
● Trim Locks
● Back Boxes
● Back Box Endwalls
● Trims
● Neutrals
● Ground Bars
● Isolated Ground Bars
● Branch Deadfront Covers
● Main Breakers
● Branch Breakers
● Branch Breaker Connector Kits
For more information, contact your local
Cutler-Hammer Field Sales Office or call
the Sumter Aftermarket Center at
1-800-556-4569.
NP
Ground Bar
Trim
Connector Kits
Each kit contains two sets of A, B, and C
phase connectors, phase isolators, hardware
and instructions for mounting up to
12 poles. Silver plated copper connectors
are suitable for use with copper or aluminum
bus. Maximum amperes connected
to any one connector cannot exceed
140A.
Panel Type Catalog Number
PRL1 KPRL1BAB
PRL2 KPRL2GHB
PANELBOARDS
General Information
105
If a connector strap kit is not available
and connectors are required to install a
replacement breaker, in most cases, the
customer should replace the entire panel.
Any breakers, connectors, and parts from
the old panel that are in usable condition
should be retained for repair of other panels
of the same type and vintage.
B