molded case circuit breakers - Eaton Canada
molded case circuit breakers - Eaton Canada
molded case circuit breakers - Eaton Canada
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
PRODUCT DESCRIPTION<br />
Originally a Cutler-Hammer Product<br />
Introduced in 1956, the 9800 was<br />
Cutler-Hammer’s initial offering in the motor<br />
control center product grouping. The<br />
door of the unit measured 19-3/8 inches<br />
wide and the bucket width measured<br />
16-1/8 inches. Unit height was measured<br />
in 9-1/3-inch and 14-inch increments. The<br />
MCC did not utilize a wireway.<br />
ANSI 49 was applied to the units, structural<br />
framework, roof, sidesheets, and all exterior<br />
doors.<br />
9800 starter units were originally supplied<br />
with a 3-Star starter and a rotary handle<br />
mechanism. Replacements today utilize<br />
the newer Citation starter and a slider handle<br />
mechanism and new door. The rotary<br />
handle mechanism is no longer available.<br />
Bus and bus systems were typically braced<br />
to withstand fault currents of 25,000A.<br />
REPLACEMENT CAPABILITIES<br />
Replacement Starter Units<br />
Replacement starter cell units are available<br />
for all plug-in MCC designs. A complete<br />
unit for adding to an existing MCC<br />
includes a unit door, divider pan, and all<br />
necessary mounting hardware. Features<br />
of the replacement unit include:<br />
● Size 1-4 starter units<br />
● UL labeled<br />
● Series C disconnect device<br />
● Citation, Freedom or ADVANTAGE<br />
starter<br />
● New tin-plated copper stab assembly<br />
● New door, handle mechanism and<br />
hardware<br />
Unit with ADVANTAGE Starter<br />
March 2001<br />
MOTOR CONTROL CENTERS<br />
9800<br />
Maximum Ratings:<br />
3-phase, 600V, 100 HP, 2500A bus<br />
Unit with Citation Starter<br />
Don’t forget the option to<br />
upgrade to ADVANTAGE.<br />
● Solid-state<br />
● Communication capability<br />
● Reduced coil wear<br />
● No heater<br />
● Smaller size<br />
● Built-in over-current and<br />
ground fault protection<br />
Replacement Feeder Units<br />
211<br />
Replacement feeder cell units are available<br />
for all plug-in MCC designs. A complete<br />
unit for adding to an existing MCC<br />
includes a unit door, divider pan and all<br />
necessary mounting hardware. Features<br />
of the replacement unit include:<br />
● Feeder <strong>breakers</strong> and fusible switches<br />
through 400A<br />
● UL labeled<br />
● Series C disconnect device<br />
● New tin-plated copper stab assembly<br />
● New door, handle mechanism and<br />
hardware<br />
9800 Feeder Unit<br />
O
Change language