Junos® OS Ethernet Interfaces Configuration ... - Juniper Networks

Configuring the Maximum Links Limit
Related
Documentation
To configure the maximum links limit, use the maximum-links statement at the [edit
chassis aggregated-devices] hierarchy level:
•
[edit chassis aggregated-devices]
maximum-links maximum-links-limit;
Configuring an Aggregated Ethernet Interface on page 83
• Junos® OS Ethernet Interfaces
Deleting an Aggregated Ethernet Interface
Related
Documentation
There are two approaches to deleting an aggregated Ethernet interface:
• You can delete an aggregated Ethernet interface from the interface configuration. The
Junos OS removes the configuration statements related to aex and sets this interface
to down state.
• You can also permanently remove the aggregated Ethernet interface from the device
configuration by deleting it from the device-count on the routing device.
To delete an aggregated Ethernet interface:
1. Delete the aggregated Ethernet configuration.
This step changes the interface state to down and removing the configuration
statements related to aex.
[edit]
user@host# delete interfaces aex
2. Delete the interface from the device count.
•
[edit]
user@host# delete chassis aggregated-devices ethernet device-count
Configuring an Aggregated Ethernet Interface on page 83
• Configuring the Number of Aggregated Ethernet Interfaces on the Device on page 112
• Aggregated Ethernet Interfaces Overview on page 81
• Junos® OS Ethernet Interfaces
Configuring Multichassis Link Aggregation
Copyright © 2012, Juniper Networks, Inc.
Chapter 4: Configuring Aggregated Ethernet Interfaces
On MX Series routers, multichassis link aggregation (MC-LAG) enables a device to form
a logical LAG interface with two or more other devices. MC-LAG provides additional
benefits over traditional LAG in terms of node level redundancy, multi-homing support,
and loop-free Layer 2 network without running Spanning Tree Protocol (STP). MC-LAG
87