Junos® OS Ethernet Interfaces Configuration ... - Juniper Networks

Related
Documentation
You can specify the discovery mode used for IEEE 802.3ah OAM support. The discovery
process is triggered automatically when OAM IEEE 802.3ah functionality is enabled on
a port. Link monitoring is done when the interface sends periodic OAM PDUs.
To configure the discovery mode, include the link-discovery statement at the [edit protocol
oam ethernet link-fault-management interface interface-name] hierarchy level:
[edit protocol oam ethernet link-fault-management interface interface-name]
link-discovery (active | passive);
In active mode, the interface discovers and monitors the peer on the link if the peer also
supports IEEE 802.3ah OAM functionality. In passive mode, the peer initiates the discovery
process. After the discovery process has been initiated, both sides participate in discovery.
•
link-discovery on page 497
• IEEE 802.3ah OAM Link-Fault Management Overview on page 291
• Configuring IEEE 802.3ah OAM Link-Fault Management on page 293
• Enabling IEEE 802.3ah OAM Support on page 294
• Configuring the OAM PDU Interval on page 295
• Configuring the OAM PDU Threshold on page 296
• Configuring Threshold Values for Local Fault Events on an Interface on page 297
• Disabling the Sending of Link Event TLVs on page 298
• Detecting Remote Faults on page 299
• Configuring an OAM Action Profile on page 300
• Specifying the Actions to Be Taken for Link-Fault Management Events on page 301
• Monitoring the Loss of Link Adjacency on page 303
• Monitoring Protocol Status on page 303
• Configuring Threshold Values for Fault Events in an Action Profile on page 305
• Applying an Action Profile on page 305
• Setting a Remote Interface into Loopback Mode on page 306
• Enabling Remote Loopback Support on the Local Interface on page 307
• Example: Configuring IEEE 802.3ah OAM Support on an Interface on page 308
• Junos® OS Ethernet Interfaces
Configuring the OAM PDU Interval
Copyright © 2012, Juniper Networks, Inc.
Periodic OAM PDUs are sent to perform link monitoring.
Chapter 16: Configuring IEEE 802.3ah OAM Link-Fault Management
You can specify the periodic OAM PDU sending interval for fault detection.
To configure the sending interval, include the pdu-interval statement at the [edit protocol
oam ethernet link-fault-management interface interface-name] hierarchy level:
295