Junos® OS Ethernet Interfaces Configuration ... - Juniper Networks

List of Figures
Part 2 Configuring Ethernet Interfaces
Chapter 4 Configuring Aggregated Ethernet Interfaces . . . . . . . . . . . . . . . . . . . . . . . . . . 81
Figure 1: Single Multichassis Link . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90
Figure 2: Dual Multichassis Link . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90
Figure 3: Interchassis Data Link Between Active-Active Nodes . . . . . . . . . . . . . . . 91
Figure 4: Active-Active MC-LAG with Single MC-LAG . . . . . . . . . . . . . . . . . . . . . . . 91
Figure 5: Active-Active MC-LAG with Multiple Nodes on a Single Multichassis
Link . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 91
Figure 6: MC-LAG Device and Single-Homed Client . . . . . . . . . . . . . . . . . . . . . . . . 92
Figure 7: Loop Caused by the ICL Links . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 94
Figure 8: Multicast Topology with Source Connected via Layer 3 . . . . . . . . . . . . . 96
Figure 9: Multicast Topology with Source Connected via MC-Link . . . . . . . . . . . . 97
Figure 10: N1 and N2 for the Same Service with Same Service ID . . . . . . . . . . . . . 102
Figure 11: Bridge Domain with Logical Interfaces from Two MC-AE Interfaces . . . 102
Figure 12: Typical Network Over Which Active-Active Is Supported . . . . . . . . . . . 105
Figure 13: Layer 2 Configuration Without Integrated Routing and Bridging . . . . . . 107
Figure 14: Symmetric Load Balancing on an 802.3ad LAG on MX Series
Routers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 125
Chapter 8 Configuring TCC and Layer 2.5 Switching . . . . . . . . . . . . . . . . . . . . . . . . . . . . 163
Figure 15: Topology of Layer 2.5 Translational Cross-Connect . . . . . . . . . . . . . . . 166
Chapter 10 Configuring Restricted and Unrestricted Proxy ARP . . . . . . . . . . . . . . . . . . . 169
Figure 16: Edge Device Case for Unrestricted Proxy ARP . . . . . . . . . . . . . . . . . . . . 170
Figure 17: Core Device Case for Unrestricted Proxy ARP . . . . . . . . . . . . . . . . . . . . . 171
Chapter 13 Configuring IEEE 802.1ag OAM Connectivity-Fault Management . . . . . . . . 181
Figure 18: Relationship Among MEPs, MIPs, and Maintenance Domain Levels . . 182
Figure 19: Relationship Among Bridges, Maintenance Domains, Maintenance
Associations, and MEPs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 183
Figure 20: Scope of the E-LMI Protocol . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200
Figure 21: E-LMI Configuration for a Point-to-Point EVC (SVLAN) Monitored by
CFM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 203
Figure 22: CET inter-op Dual Homed Topology . . . . . . . . . . . . . . . . . . . . . . . . . . . 221
Figure 23: CET inter-op Dual Attached Topology . . . . . . . . . . . . . . . . . . . . . . . . . 222
Figure 24: Layer 2 VPN Topology . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 224
Chapter 14 Configuring ITU-T Y.1731 Ethernet Service OAM . . . . . . . . . . . . . . . . . . . . . . 237
Figure 25: Relationship of MEPs, MIPs, and Maintenance Domain Levels . . . . . . 240
Chapter 22 Configuring 10-Gigabit Ethernet LAN/WAN PICs . . . . . . . . . . . . . . . . . . . . . 341
Copyright © 2012, Juniper Networks, Inc.
Figure 26: Control Queue Rate Limiter Scenario . . . . . . . . . . . . . . . . . . . . . . . . . 346
xxiii