Junos® OS Ethernet Interfaces Configuration ... - Juniper Networks

Related
Documentation
You can specify the following LLDP-specific options in the LLDP traceoptions statement:
• all—Trace all operations.
• config—Log configuration events.
• interface—Trace interface update events.
• protocol—Trace protocol information.
• rtsock—Trace real-time socket events.
• vlan—Trace VLAN update events.
NOTE: Use the trace flag all with caution. This flag may cause the CPU to
become very busy.
For general information about tracing and global tracing options, see the statement
summary for the global traceoptions statement in the Junos OS Routing Protocols
Configuration Guide.
Example: Configuring LLDP
Copyright © 2012, Juniper Networks, Inc.
•
LLDP Overview on page 157
• Configuring LLDP on page 158
• Example: Configuring LLDP on page 161
• LLDP Operational Mode Commands
The following example configures LLDP on interface ge-1/1/1 but disables LLDP on all
other interfaces, explicitly configures the default values for all automatically enabled
features, and configures a value of 30 seconds for the LLDP configuration notification
interval and a value of 30 seconds for the physical topology trap interval.
[edit]
protocols {
lldp {
advertisement-interval 30;
hold-multiplier 4;
interface all {
disable;
}
interface ge-1/1/1;
lldp-configuration-notification-interval 30;
ptopo-configuration-maximum-hold-time 300;
ptopo-configuration-trap-interval 30;
transmit-delay 2;
}
}
Chapter 7: Configuring Link Layer Discovery Protocol
161