Junos® OS Ethernet Interfaces Configuration ... - Juniper Networks

[edit protocols oam]
ethernet {
connectivity-fault-management {
action-profile test {
event {
interface-status-tlv down;
}
action {
propagate-remote-mac-flush;
}
clear-action {
propagate-remote-mac-flush;
}
}
}
}
In this action profile configuration, when the incoming CCM packet contains the
interface-status TLV with value down, the propagate-remote-mac-flush action is triggered
for the action-profile.
Configuring a Primary VLAN ID
You can assign a primary virtual LAN (VLAN) ID in the maintenance association for
increased flexibility in the number of tags. When a vlan-range or vlan-id-list is configured
on an interface, the service OAM must run on one of the VLANs. The VLAN assigned for
service monitoring is considered the primary VLAN. If a primary-vid is not configured,
Junos OS assigns the first VLAN from the vlan-range or vlan-id-list. In earlier releases,
Junos OS assigned VLAN 4095.
To configure a primary VLAN ID, you can specify the primary-vid statement at the [edit
protocols oam ethernet connectivity-fault-management maintenance-domain domain-name
maintenance-association ma-name] hierarchy level:
[edit protocols oam ethernet connectivity-fault-management]
maintenance domain md3 {
level 3;
maintenance-association ma3 {
primary-vid 2000;
continuity-check {
interval 10ms;
connection-protection-tlv;
}
mep 2 {
interface ge-2/2/0.0;
direction up;
auto-discovery;
}
}
}
Configuring a Remote Maintenance Association
Copyright © 2012, Juniper Networks, Inc.
Chapter 13: Configuring IEEE 802.1ag OAM Connectivity-Fault Management
You can configure a maintenance association to accept a different maintenance
association identifier (ID) from a neighbor by including a remote-maintenance-association
235