Junos® OS Ethernet Interfaces Configuration ... - Juniper Networks

Junos ®
OS 12.3 Ethernet Interfaces Configuration Guide
Related
Documentation
The following features are not supported on the 100-Gigabit Ethernet Type 5 PIC:
• MAC filtering, accounting, and policing for destination MAC at the logical interface
level.
NOTE: Because destination MAC filtering is not supported, the hardware
is configured to accept all the multicast packets. This configuration enables
the OSPF protocol to work.
• Premium MAC policers at the logical interface level.
• MAC filtering, accounting, and policing at the physical interface level.
• Multiple TPIDs.
• IP service for nonstandard TPID.
Table 35 on page 374 lists the capabilities of 100-Gigabit Ethernet PICs on Type 5 FPC.
Table 35: Capabilities of 100-Gigabit Ethernet PICs on Type 5 FPC
•
Capability
Maximum logical interfaces per PIC
Maximum logical interfaces per port
Configuring 100-Gigabit Ethernet PICs on page 367
• Configuring Gigabit Ethernet Policers on page 317
• Configuring MAC Address Filtering on page 321
Support
4093
For IPv4 the limit is 4093.
For IPv6 the limit is 1022.
• Stacking and Rewriting Gigabit Ethernet VLAN Tags Overview on page 129
Interoperability Between the 100-Gigabit Ethernet PICs PD-1CE-CFP-FPC4 and
PF-1CGE-CFP
374
You can enable interoperability between the 100-Gigabit Ethernet PICs PD-1CE-CFP-FPC4
and PF-1CGE-CFP by:
• Enabling source address (SA) multicast bit steering mode on the 100-Gigabit Ethernet
PIC PF-1CGE-CFP.
• Configuring the two 50-Gigabit Ethernet physical interfaces on the 100-Gigabit Ethernet
PIC PD-1CE-CFP-FPC4 as one aggregated Ethernet physical interface.
SA multicast mode uses the multicast bit in the source MAC address for packet steering.
By default, the SA multicast bit is set to 0 for all packets sent by the 100-Gigabit Ethernet
PIC PF-1CGE-CFP. The 100-Gigabit Ethernet PIC PD-1CE-CFP-FPC4 looks at the bit and
Copyright © 2012, Juniper Networks, Inc.