Junos® OS Ethernet Interfaces Configuration ... - Juniper Networks

Related
Documentation
Copyright © 2012, Juniper Networks, Inc.
NOTE: Maintenance intermediate points (MIP) are not supported on the ACX
Series routers.
A maintenance association is a set of MEPs configured with the same maintenance
association identifier and maintenance domain level. Figure 19 on page 183 shows the
hierarchical relationships between the Ethernet bridge, maintenance domains,
maintenance associations, and MEPs.
Figure 19: Relationship Among Bridges, Maintenance Domains,
Maintenance Associations, and MEPs
•
connectivity-fault-management
• Creating the Maintenance Domain on page 184
• Configuring Maintenance Intermediate Points on page 185
• Creating a Maintenance Association on page 187
• Continuity Check Protocol on page 188
• Configuring a Maintenance Endpoint on page 191
• Configuring a Connectivity Fault Management Action Profile on page 196
• Configuring Linktrace Protocol in CFM on page 199
• Configuring Ethernet Local Management Interface on page 200
• Configuring Port Status TLV and Interface Status TLV on page 208
• Configuring MAC Flush Message Processing in CET Mode on page 220
• Configuring M120 and MX Series Routers for CCC Encapsulated Packets on page 223
• Configuring Rate Limiting of Ethernet OAM Messages on page 225
• Configuring 802.1ag Ethernet OAM for VPLS on page 228
• Junos® OS Ethernet Interfaces
Chapter 13: Configuring IEEE 802.1ag OAM Connectivity-Fault Management
183