Junos® OS Ethernet Interfaces Configuration ... - Juniper Networks

[edit protocols oam ethernet connectivity-fault-management performance-monitoring
sla-iterator-profiles i1]
disable;
cycle-time 1000;
iteration-period 2000;
measurement-type two-way-delay;
calculation-weight {
delay 1;
delay-variation 1;
}
Example: Disabling an Iterator Profile by Deactivating the Profile
Related
Documentation
Disabling an iterator profile i2 with the deactivate command for a remote MEP whose
value is 1:
•
[edit protocols oam ethernet connectivity-fault-management maintenance-domain
default-1 maintenance association ma1 mep 1]
remote-mep 1 {
deactivate sla-iterator-profile i2;
}
Proactive Mode on page 246
• Clearing Iterator Statistics on page 275
• Configuring an Iterator Profile on page 249
• Configuring a Remote MEP with an Iterator Profile on page 250
• Displaying Iterator Statistics on page 270
• Managing Iterator Statistics on page 270
• Junos® OS Ethernet Interfaces
Configuring the Failure Notification Protocol
Copyright © 2012, Juniper Networks, Inc.
This topic describes how to configure the Ethernet Operations, Administration, and
Maintenance (OAM) Failure Notification Protocol (FNP) on MX Series routers. The FNP
detects link failures in a Carrier Ethernet network and broadcasts FNP messages when
a failure occurs to all nodes affected by the link failure. To configure FNP functionality,
include the fnp statement at the [edit protocols oam ethernet] hierarchy level:
[edit protocols oam]
ethernet {
fnp {
interval ;
loss-threshold number
interface interface name {
domain-id domain-id
}
}
}
Chapter 14: Configuring ITU-T Y.1731 Ethernet Service OAM
285