Junos® OS Ethernet Interfaces Configuration ... - Juniper Networks

Junos ®
OS 12.3 Ethernet Interfaces Configuration Guide
292
Related
Documentation
The features of link-fault management are:
• Discovery
• Link monitoring
• Remote fault detection
• Remote loopback
The following features are not supported:
• Ethernet running on top of a Layer 2 protocol, such as Ethernet over ATM, is not
supported in OAM configurations.
• Remote loopback is not supported on the 10-Gigabit Ethernet LAN/WAN PIC with
SFP+.
• The remote loopback feature mentioned in section 57.2.11 of IEEE 802.3ah is not
•
supported on T4000 routers.
NOTE: Aggregated Ethernet member links will now use the physical MAC
address as the source MAC address in 802.3ah OAM packets.
Configuring IEEE 802.3ah OAM Link-Fault Management on page 293
• Enabling IEEE 802.3ah OAM Support on page 294
• Configuring Link Discovery on page 294
• Configuring the OAM PDU Interval on page 295
• Configuring the OAM PDU Threshold on page 296
• Configuring Threshold Values for Local Fault Events on an Interface on page 297
• Disabling the Sending of Link Event TLVs on page 298
• Detecting Remote Faults on page 299
• Configuring an OAM Action Profile on page 300
• Specifying the Actions to Be Taken for Link-Fault Management Events on page 301
• Monitoring the Loss of Link Adjacency on page 303
• Monitoring Protocol Status on page 303
• Configuring Threshold Values for Fault Events in an Action Profile on page 305
• Applying an Action Profile on page 305
• Setting a Remote Interface into Loopback Mode on page 306
• Enabling Remote Loopback Support on the Local Interface on page 307
• Example: Configuring IEEE 802.3ah OAM Support on an Interface on page 308
• Junos® OS Ethernet Interfaces
Copyright © 2012, Juniper Networks, Inc.