Junos® OS Ethernet Interfaces Configuration ... - Juniper Networks

Junos ®
OS 12.3 Ethernet Interfaces Configuration Guide
Related
Documentation
[edit protocols oam ethernet connectivity-fault-management performance-monitoring
sla-iterator-profiles i1]
user@host# set calculation-weight delay-variation delay-variation-value
9. Configure the disable statement to stop the iterator (that is, disable the iterator profile).
[edit protocols oam ethernet connectivity-fault-management performance-monitoring
sla-iterator-profiles i1]
user@host# set disable
10. Verify the configuration.
•
[edit protocols oam ethernet connectivity-fault-management performance-monitoring
sla-iterator-profiles]
user@host# show i1
cycle-time cycle-time-value;
iteration-period iteration-period-value;
measurement-type (loss | two-way-delay);
calculation-weight {
delay delay-weight;
delay-variation delay-variation-weight;
}
Proactive Mode on page 246
• Clearing Iterator Statistics on page 275
• Configuring a Remote MEP with an Iterator Profile on page 250
• Example: Configuring an Iterator on page 283
• Displaying Iterator Statistics on page 270
• Managing Iterator Statistics on page 270
• Junos® OS Ethernet Interfaces
Configuring a Remote MEP with an Iterator Profile
250
You can associate a remote maintenance association end point (MEP) with more than
one iterator profile.
To configure a remote MEP with an iterator profile:
1. In configuration mode, go to the following hierarchy level:
user@host# edit protocols oam ethernet connectivity-fault-management
maintenance-domain md-name maintenance-association ma-name mep mep-id
2. Configure the remote MEP with values from 1 through 8191.
[edit protocols oam ethernet connectivity-fault-management maintenance-domain
md-name maintenance-association ma-name mep mep-id]
user@host# set remote-mep remote-mep-id
3. Set the iterator profile.
Copyright © 2012, Juniper Networks, Inc.