Junos® OS Ethernet Interfaces Configuration ... - Juniper Networks

Junos ®
OS 12.3 Ethernet Interfaces Configuration Guide
Related
Documentation
local-request- Configuring this value to lockout or force-switch will trigger lockout or
force-switch operation on the protection groups using this profile.
•
Mapping of CCM Defects to APS Events on page 432
• Example: Configuring Protection Switching Between Psuedowires on page 433
Mapping of CCM Defects to APS Events
432
The continuity check message (CCM) engine marks the status of working and protected
transport entities as either Down, Degraded, or Up.
Down—The monitored path is declared down if any of the following Multiple End Point
(MEP) defects occur:
• Interface down
• CCM expiry
• RDI indicating signal failure
Degraded—The monitored path is declared degraded if any of the following MEP defects
occur:
• FRR on
• FRR-ACK on
Up—The monitored path is declared up in the absence of any of the above events.
Figure 31: Understanding APS Events
Working
Protection
Up
Down
Degraded
Up
Down
Degraded
APS
Event
Generator
As show in Figure 31 on page 432, the APS event generator generates the following APS
events based on the status of the working and protection paths:
• SF—Signal failure on working path
• RSF—Working path recovers from signal failure
• SF-P—Signal failure on protection path
• RSF-P—Protection path recovers from signal failure
g017520
Copyright © 2012, Juniper Networks, Inc.