EQ7 Series Instruction Manual - TECO-Westinghouse Motor Company

2.4 Mounting and Connecting the Keypad
The standard keypad TP-G1W-J1 meets UL Type 4 (NEMA4) by itself.
• On the panel or at a remote site
The keypad can be mounted on the panel wall as shown below or installed at a remote site for operation on hand.
Mount the keypad with four M3 x 12 screws provided--two fine thread
screws and two coarse thread tapping screws. The recommended
tightening torque is 6.2 lb-in (0.7 Nm).
For panel cutting dimensions, refer to Chapter 11, Section 11.3.2.
RJ-45
connector
Panel
0.51 inches (13 mm)
(Effective length of
tapping screw)
M3 x 12
(Coarse thread tapping screws)
M3 x 12
(Fine thread screws)
0.43 inches (11 mm)
(Effective length of
screw)
Inside the panel
0.05 to 0.09 inch*
(1.2 to 2.3 mm)
* If the thickness of the panel wall is out of
the range specified above, use screws of
an appropriate length.
Figure 2.21 Mounting the Keypad on the Panel Wall
To mount the keypad on a place other than an inverter, the parts listed below are needed.
Parts name Type Remarks
Extension cable
LAN cable
0BASE-T/100BASE-TX straight type cable
compliant with US ANSI/TIA/EIA-568A Category 5. (Less than 66 ft (20 m))
• On the inverter
To remove the keypad from the inverter, pull it forward while holding down the hook (pointed by the arrow in Figure
2.22). When mounting it, put the keypad back into place in the reverse order of removal.
Figure 2.22 Removing the Keypad
2-27