EQ7 Series Instruction Manual - TECO-Westinghouse Motor Company

(3) Press key to establish the desired menu and proceed to a list of monitoring items.
((5) To go back to the menu screen, press key.)
/
Output frequency (before slip compensation)
Output frequency (after slip compensation)
Output current
Output voltage
1/8: Page # in operation guide, means that this page continues to the next page.
(4) Use and keys to select the page on which the desired monitor item is shown.
Calculated torque
Reference frequency
Running status (See Table 3.7.)
/
Motor speed
Load shaft speed
Line speed
Constant peripheral speed control monitor
/
PID command value
PID feedback amount
PID output value
/
Torque limit value A
Torque limit value B
Reserved.
/
Current position pulse
Stop position target pulse
Position deviation pulse
Positioning control status
/
Motor temperature
Ratio setting
Magnetic flux command value
Deviation in SY synchronous operation
/
Current position pulse
Stop position target pulse
Position deviation pulse
Reserved.
: End of page
Common operation items
To access the target data, switch to the desired page using the and keys.
: This page continues to the next page.
: This page is continued from the previous page and continues to the next page.
: This page is continued from the previous page.
Figure 3.12 Screen Transition for "Drive Monitoring"
3-14