EQ7 Series Instruction Manual - TECO-Westinghouse Motor Company

Code Name Data setting range
Item values in parentheses indicated value for negative logic.
Y: Applicable / N: Not Applicable.
Change when
running
Data copying
Default
setting
Drive control
V/f
Vector
Refer to
Control w/ Torque Page
w/o PG control
PG
Y Y Y Y 4-71
4-104
30 (1030): Force to stop (STOP)
(30 = Active OFF, 1030 = Active ON)
32 (1032): Pre-excitation (EXITE) N Y Y N
33 (1033): Reset PID integral and differential
components (PID-RST) Y Y Y N
34 (1034): Hold PID integral component (PID-HLD) Y Y Y N
35 (1035): Select local (keypad) operation (LOC) Y Y Y Y
39: Protect motor from dew condensation (DWP) Y Y Y Y
40: Enable integrated sequence to switch
to commercial power (50 Hz) (ISW50) Y N N N
41: Enable integrated sequence to switch
to commercial power (60 Hz) (ISW60) Y N N N
47 (1047): Servo-lock command (LOCK) N N Y N
49 (1049): Pulse train sign (SIGN)
Y Y Y Y
59 (1059): Enabled battery operation (BATRY)
Y Y Y Y
70 (1070): Cancel constant peripheral speed
Y Y Y N
control
(Hz/LSC)
71 (1071): Hold the constant peripheral speed
Y Y Y N
control frequency in the memory(LSC-HLD)
72 (1072): Count the run time of commercial
power-driven motor 1 (CRUN-M1) Y N N Y
73 (1073): Count the run time of commercial
power-driven motor 2 (CRUN-M2) Y N N Y
76 (1076): Select droop control (DROOP) Y Y Y N
77 (1077): Cancel PG alarm (PG-CCL) N N Y Y
80 (1080): Cancel customizable logic (CLC) Y Y Y Y
81 (1081): Clear all customizable logic timers (CLTC) Y Y Y Y
98: Run forward (FWD) Y Y Y Y
99: Run reverse (REV) Y Y Y Y
100: No function assigned (NONE) Y Y Y Y
Setting the value in parentheses ( ) shown above
assigns a negative logic input to a terminal.
4-10