EQ7 Series Instruction Manual - TECO-Westinghouse Motor Company

3.4 Programming Mode
Programming mode provides you with these functions--setting and checking function code data, monitoring
maintenance information and checking input/output (I/O) signal status. These functions can be easily selected with a
menu-driven system. Table 3.5 lists menus available in Programming mode.
When the inverter enters Programming mode from the second time on, the menu selected last in Programming mode
will be displayed.
Table 3.5 Menus Available in Programming Mode
Menu # Menu Used to:
User
Manual
Section:
0 Quick Setup Display only basic function codes previously selected. 3.4.1
1 Data Setting
2 Data Checking
3 Drive Monitoring
Display and change the data of the function code selected.
(Note)
Display the function code selected and its data on the same
screen. Also this menu is used to change the function code
data or check whether the data has been changed from the
factory default.
Display the running information required for maintenance or
test running.
4 I/O Checking Display external interface information. 3.4.5
5 Maintenance Information
6 Alarm Information
Display maintenance information including cumulative run
time.
Display the recent four alarm codes. Also this menu is used
to view the information on the running status at the time the
alarm occurred.
7 Alarm Cause Display the cause of the alarm. 3.4.8
8 Data Copying Read or write function code data, as well as verifying it. 3.4.9
9
Load Factor
Measurement
Measure the maximum output current, average output
current, and average braking power.
3.4.2
3.4.3
3.4.4
3.4.6
3.4.7
3.4.10
10 User Setting Add or delete function codes covered by Quick Setup. 3.4.11
11
Communication
Debugging
Confirm the data of function codes exclusively designed for
communication (S, M, W, X, and Z codes).
3.4.12
Figure 3.7 shows the transitions between menus in Programming mode.
Figure 3.7 Menu Transition in Programming Mode
If no key is pressed for approx. 5 minutes, the inverter automatically goes back to Running mode and turns the backlight
OFF.
3-8