EQ7 Series Instruction Manual - TECO-Westinghouse Motor Company

I/O signals (option) (in hex.) (See Note 2 given below.)
Input signal
Output signal
Pulse rate signal
/
PG pulse rate (option)
A/B phase signal from reference PG
Z phase signal from reference PG
A/B phase signal from slave PG
Z phase signal from slave PG
/
Analog I/O signals (option)
Input voltage at terminal [32]
Input current at terminal [C2]
Output voltage at terminal [A0]
Output current at terminal [CS]
Common operation items
To access the target data, switch to the desired page using the and keys.
: This page continues to the next page.
: This page is continued from the previous page and continues to the next page.
: This page is continued from the previous page.
Figure 3.13 Screen Transition for "I/O Checking"
Note: “---“shown on the display indicates an option card that is not installed.
3-17