EQ7 Series Instruction Manual - TECO-Westinghouse Motor Company

Table 3.7 Drive Monitoring Items (Continued)
Page # in
operation
guide
4
5
6
7
8
Item Symbol Description
PID command value SV The PID command value and PID feedback amount are displayed
after conversion to the virtual physical values (e.g., temperature
or pressure) of the object to be controlled using function code E40
PID feedback amount
PV
and E41 data (PID display coefficients A and B).
Display value = (PID command value or feedback amount)
(Coefficient A - B) + B
PID output value
MV
PID output value, displayed in % (assuming the maximum
frequency (F03) as 100%).
Torque limit value A TLA Driving torque limit value A (based on motor rated torque)
Torque limit value B TLB Driving torque limit value B (based on motor rated torque)
Reference torque bias TRQB Reserved.
Current position pulse P Current position pulse for positioning control
Stop position target pulse E Stop position target pulse for positioning control
Position deviation pulse dP Position deviation pulse for positioning control
Positioning control status MODE Positioning control status
Motor temperature NTC Temperature detected by the NTC thermistor built in the motor
Ratio setting
Magnetic flux command
value
Deviation in SY synchronous
operation
Current position pulse,
4-multiplied
Stop position target pulse,
4-multiplied
Position deviation pulse,
4-multiplied
Rati
When this setting is 100%, the LED monitor shows 1.00 time of
the value to be displayed.
FLUX Flux command value in %.
SY-d
P4
E4
dP4
Positioning control status MODE Reserved.
Deviation in SY synchronous operation
Current position pulse for positioning control
Stop position target pulse for positioning control
Position deviation pulse for positioning control
Basic key operation
(1) Turn the inverter ON. It automatically enters Running mode. In that mode, press the key to switch to
Programming mode and display the menu screen.
(2) Move the pointer to "3. OPR MNTR" with the and keys.
(3) Press the key to establish the selected menu and proceed to a list of monitoring items (consisting of several
pages).
(4) Use the and keys to select the page on which the desired monitoring item is shown, then check the running
status information of that item.
(5) Press the key to go back to the menu screen.
Figure 3.12 shows an example of the LCD screen transition starting from Menu #3 "Drive Monitoring."
(1) To display this menu screen, press key in Running mode to switch to Programming mode.
(2) Move the pointer to "3. OPR MNTR" with and keys.
/
Select desired menu by moving the pointer with / key.
3-13