Tsunami MP.11 Installation and Management Model 5012-SUR ...

Tsunami MP.11 5012-SUR Installation and Management
Procedures
9
This chapter describes the following procedures:
• TFTP Server Setup: Prepares the TFTP server for transferring files to and from the 5012-SUR. This procedure is
used by the other procedures that transfer files.
• Web Interface Image File Download: Upgrades the embedded software.
• Configuration Backup: Saves the configuration of the 5012-SUR.
• Configuration Restore: Restores a previous configuration through configuration file download.
• Soft Reset to Factory Default: Resets the 5012-SUR to the factory default settings through the Web or Command
Line Interface.
• Hard Reset to Factory Default: In some cases, it may be necessary to revert to the factory default settings (for
example, if you cannot access the 5012-SUR or you lost the password for the Web Interface).
• Forced Reload: Completely resets the 5012-SUR and erases the embedded software. Use this procedure only as a
last resort if the 5012-SUR does not boot and the “Hard Reset to Factory Default” procedure did not help. If you
perform a “Forced Reload,” you must download a new image file as described in Image File Download with the
Bootloader.
• Image File Download with the Bootloader: If the 5012-SUR does not contain embedded software, or the embedded
software is corrupt, you can use this procedure to download a new image file.
121