Tsunami MP.11 Installation and Management Model 5012-SUR ...

More documents

Recommendations

Info

Configuration Tsunami MP.11 5012-SUR Installation and Management System Parameters If the average packet size is 1000 bytes, the overhead saved is 1.5%; With a frame size of 64 bytes, the overhead saved is 20%; and for frame sizes of 128 bytes, the saving is 10%. Network researches claim that most network traffic consists of frames smaller than 100 bytes. In order to support routers behind the SUs with multiple subnets and prevent routing loops, you want individual routes (and more then one) per SU. Routing Mode Examples In the first example, both the BSU and the SUs are configured for Routing mode. This example is appropriate for businesses connecting remote offices that have different networks. In example 2, the BSU is in Routing mode and the SUs are in Bridge mode. Notice the PCs behind the SUs must configure their default gateways to point to the BSU, not the SU. Notes: • One of the most important details to pay attention to in Routing mode are the unit’s and the PC’s default gateways. It is a common mistake to set up the PC’s gateway to point to the SU when the SU is in Bridge mode and the BSU is in Routing mode. Always check to make sure the PCs on your network are configured to send their IP traffic to the correct default gateway. • Be sure to reboot the unit to permanently save static routes. New routes take effect immediately without a reboot, but are not permanently saved with your configuration until you do reboot the device. An unexpected power outage could cause static routes you entered to “disappear” when the unit reboots if they have not been saved. You also should save a copy of your unit’s configuration file in case the unit must be reloaded. This saves you from being required to re-enter numerous static routes in a large network. • The routing table supports up to 500 static routes. 60
Configuration Tsunami MP.11 5012-SUR Installation and Management Network Parameters Network Parameters The Network tab contains the following sub-tabs. Note that some configuration options are available only in Routing mode. • IP Parameters • Roaming • DHCP Server • Spanning Tree (Bridge Mode Only) • SNTP-DNS • SNTP-DNS • DHCP Relay Agent (Routing Mode only) IP Parameters Click Configure > Network > IP Configuration to view and configure local IP address information. Configurable settings differ between Bridge mode and Routing mode. Bridge Mode If the device is configured in Bridge mode, the following screen is displayed: Configure or view the following parameters: • IP Address Assignment Type: – Select Static if you want to assign a static IP address to the unit. Use this setting if you do not have a DHCP server or if you want to manually configure the IP settings – Select Dynamic to have the device run in DHCP client mode, which gets an IP address automatically from a DHCP server over the network. When the unit is in Bridge mode, only one IP address is required. This IP address also can be changed with ScanTool (see Setting the IP Address with ScanTool). • IP Address: The unit’s static IP address (default IP address is 10.0.0.1). This parameter is configurable only if the IP Address Assignment Type is set to Static. 61
Page 1 and 2:
Tsunami MP.11 Installation and Mana
Page 3 and 4:
Tsunami MP.11 5012-SUR Installation
Page 5 and 6:
Page 7 and 8:
Page 9 and 10: Introduction Tsunami MP.11 5012-SUR
Page 15 and 16: Installation and Initialization Tsu
Page 29 and 30: System Overview Tsunami MP.11 5012-
Page 47 and 48: Tsunami MP.11 5012-SUR Installation
Page 49 and 50: Basic Management Tsunami MP.11 5012
Page 59: Configuration Tsunami MP.11 5012-SU
Page 63 and 64: Configuration Tsunami MP.11 5012-SU
Page 101 and 102: Monitoring Tsunami MP.11 5012-SUR I
Page 111 and 112:
Monitoring Tsunami MP.11 5012-SUR I
Page 113 and 114:
Monitoring Tsunami MP.11 5012-SUR I
Page 115 and 116:
Page 117 and 118:
Commands Tsunami MP.11 5012-SUR Ins
Page 119 and 120:
Commands Tsunami MP.11 5012-SUR Ins
Page 121 and 122:
Page 123 and 124:
Procedures Tsunami MP.11 5012-SUR I
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Troubleshooting Tsunami MP.11 5012-
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Country Codes and Channels Tsunami
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Technical Specifications Tsunami MP
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Technical Services and Support Tsun
Page 161 and 162:
show all

Tsunami MP.11 Installation and Management Model 5012-SUR ...

Create successful ePaper yourself

Delete template?

Save as template?