Operating Manual

OPERATING MANUAL
• With the menu command Settings > Batching systems, you can pre-select various weighing
and batching systems ( see Section 22.4 «Batching systems settings (module weighing and
batching systems only)»).
• With the menu command Settings > Communication you can select the communications settings
(see Section 22.6 “Communication settings”).
• With the menu command Settings > Units you can activate Unit conversion (see Section 22.7
“Unit settings”).
3.6 General operating information
While you work with Ink Formulation, dialog boxes will be displayed during various sequences.
These will point out certain processes or possibilities. Please read these notes thoroughly and
carefully before you either acknowledge by clicking on OK or Yes, or interrupt the sequence with
No or Cancel.
3.6.1 Symbols
The following symbols are used:
> Ink must be contained in recipe (see following note)
$ Ink leftover
~ Ink taken from another assortment
+ Pallet recipe
! Non-proportional modified recipe
Symbol « > »
It is now possible in the Colorant selection window (during recipe calculation) to determine components,
which must be present in the recipe. For this purpose the required component must be
selected and the Modify button clicked. A window appears, in which, in addition to restriction of
the concentration, it can be stated whether the component is to appear in every recipe. If more
than one component is specified, it means that at least one must be contained in the recipe.
If the use of ink leftovers is set, all ink leftovers are automatically preselected with use in every
recipe.
26
3 • Structure and function