DocAve 6 Service Pack 3 Control Panel Reference Guide - AvePoint

If you do not configure this parameter, the value is 30 seconds bydefault.• RetryCount – Specify the count of the Retry operation when theconnection with the HDS Hitachi Content Platform server is notavailable. The format is RetryCount=6.If you do not configure this parameter, the value is 6 by default.• FlushDNS – Specify whether to flush the DNS before connecting to thespecified secondary Namespace Address. The format is FlushDNS=true.If you do not configure this parameter, the value is true by default,which means the DNS will be flushed before connecting to the specifiedsecondary Namespace Address.• FailoverMode – Specify when to use the configured secondaryNamespace Address if the primary Namespace Address is not accessible.Refer to Configuring FailoverMode for more information.oSpace Threshold – Set up the Space Threshold for the physical device. Once thethreshold is reached, data will stop being written to the physical device and thedevice will become read-only. There are two methods you can select:• Less than … MB – Specify the minimum size of the free space for thephysical device, if the free space of the physical device is less than thespecified size, data will stop being written to the physical device and thedevice will become read-only. By default, this option is used and thedefault size is 1024 MB.• Less than … % – Specify the minimum percentage of the free space, ifthe free space of the physical device is less than the specifiedpercentage, data will stop being written to the physical device and thedevice will become read-only.Click Test to verify the space or percentage you entered.Configuring FailoverModeTo configure FailoverMode, , complete the following steps:Click OK to save the configurations and return to the StorageConfiguration interface, or click Cancel to return to the StorageConfiguration interface without saving any changes. After the physicaldevice is saved, it will be listed in the Physical Device tab.• If you enter FailoverMode= ReadWrite, the secondary Namespace Address will enablethe upload and download function.• If you enter FailoverMode=Read, the secondary Namespace Address will only enablethe download function.DocAve 6: Control Panel111