DocAve 6 Service Pack 3 Control Panel Reference Guide - AvePoint

In the Summary table, you can view the schedules you configured. To delete an existingschedule, click the delete () button.• Would you like to run all of the plans in the plan group according to the plan group’sschedule? – Select the Disable the schedule for each plan and run plans according tothe plan group’s schedule checkbox to disable the schedule for each plan in the plangroup and run the plans according to the plan group’s schedule.7. Click Next on the ribbon or the Next button to go to the next step.8. Overview – Review and edit the plan group settings on this page.• To edit settings, click the Edit link above the section you want to change.• To save the configuration, click the Finish button. If you want to run the plan groups jobnow, select Finish and Run Now. If you do not want to run the job immediately, selectFinish.Configuring the Add Schedule InterfaceTo configure the Add Schedule interface, complete the following steps:• Type – Select the time unit of the time interval for this schedule from By hour, By day,By week, or By month.• Schedule Settings – Configure the frequency of the time interval for this schedule byentering a positive integer in the text box. If you want to set up a more specificschedule, select the Advanced checkbox, and refer to the instructions below.If you select By hour, select one of the following options and configure its settings:oSpecify production time: From __ to __ – Specify the production time. It will runthe plan groups in the specified production time frame.*Note: All plan group jobs that started within this time frame will finish even ifthe end time is reached.oSelect time below – Specify the time you want to run the plan group. To addseveral time points, click Add.If you select By Day, enter the frequency in terms of days into the text box.If you select By week, configure the following settings:ooEvery __ week(s) – Enter the frequency in terms of weeks.On __ – Specify the days of the week to run the plan group on.If you select By month, select one of the following options and configure its settings:oOn day __ of __ – Select the day of the specific month(s) to run the plan group.For example, if you select On day 3 of January and July, the plan groups will runon the third of January and July.DocAve 6: Control Panel169