DocAve 6 Service Pack 3 Control Panel Reference Guide - AvePoint

Configuring List Name MappingsTo create a new list name mapping, click Create on the ribbon. To modify a previously configured listname mapping, select the list name mapping, and then click Edit on the ribbon. In the Create List NameMapping or Edit List Name Mapping interface, complete the following steps:1. Configure the following settings for the List Name Mappings:a.b.Name and Description – Enter the name as you want it to appear for the new list namemapping profile. Enter an optional description for this list name mapping profile forfuture reference.Condition – Filters the condition for site and list level.ooIn the site level, click Add a Condition. In the first drop-down list, you can selectURL as a rule. In the second drop-down list, you can select Equals, Does NotEqual, Contains, or Does Not Contain as the condition. In the third text box, youcan enter the value you want to filter. If you want to configure another sitecondition, click Add a Condition to add a new site condition configuration tab.In the list level, click Add a Condition. In the first drop-down list, you can selectTemplate ID as a rule. In the second drop-down list, you can select Equals, DoesNot Equal, Contains, or Does Not Contain as condition. You can view commonlyused templates in the third text box. If you cannot find all of the templates youwant, select Customized at the bottom of the drop-down list and enter thetemplate name you want in the text box on the right. Click Add a Condition toadd a new list condition configuration tab.On the same level and same tab, the relation between conditions is AND by default. Youcan click AND and it will change to OR.c.List Name Mapping – Maps the source list name with destination list name. Enter theSource List Name and Destination List Name into the table. Click to delete apreviously configured list name mapping. You can also click Add a List Name Mapping toadd a new list name mapping.2. Click Save to save the configurations for this list name mapping, and return to the List NameMapping interface in Mapping Manager, or click Cancel to return without saving any of yourchanges.Click Close on the ribbon to close Mapping Manager.164DocAve 6: Control Panel