DocAve 6 Service Pack 3 Control Panel Reference Guide - AvePoint

Click OK to save the configurations and return to the Storage Configuration interface, or click Cancel toreturn to the Storage Configuration interface without saving any changes. After the physical device issaved, it will be listed in the Physical Device tab.OneDriveIn the Create Physical Device or Edit Physical Device interface, configure the following settings:• Physical Device Name – Enter a Physical device name and then type an optionalDescription for future reference.• Storage Type – Select OneDrive from the Storage Type drop-down list.• Storage Type Configuration – Configure the following settings:ooooooRoot Folder Name – Specify a name for the root folder which will be created inthe OneDrive and used to store the data.Client ID – Enter the client ID of any existing app.Client Secret – Enter the client secret of the corresponding app.Redirect Domain – Specify a redirect domain which is used to redirect to thespecified URL while the OneDrive cannot be connected.Refresh Token – Enter the refresh token of the corresponding app which isobtained by the OneDrive Token Tool.Advanced – Specify the following extended parameters in advanced settings ifnecessary. If you have multiple parameters to enter, press Enter on yourkeyboard to separate the parameters. Refer to the instructions below to addparameters.• RetryInterval – Customize the retry interval when the networkconnection is interrupted. You are allowed to enter any positive integerbetween 0 and 2147483646 (the unit is millisecond). For example,RetryInterval=30 represents the interval between the networkinterruption and reconnection is 30 milliseconds.• RetryCount – Customize the reconnection times after the networkconnection is interrupted. You are allowed to enter any positive integerbetween 0 and 2147483646. For example, RetryCount=10 representswhen the network connection is interrupted, it can reconnect at most10 times.Click Validation Test to verify that the information you entered is correct.• Space Threshold – Set up the Space Threshold for the physical device. Once thethreshold is reached, data will stop being written to the physical device and the devicewill become read-only. There are two methods you can select:oLess than … MB – Specify the minimum size of the free space for the physicaldevice, if the free space of the physical device is less than the specified size,DocAve 6: Control Panel113