DocAve 6 Service Pack 3 Control Panel Reference Guide - AvePoint

oodata will stop being written to the physical device and the device will becomeread-only. By default, this option is used and the default size is 1024MB.Less than … % – Specify the minimum percentage of the free space, if the freespace of the physical device is less than the specified percentage, data will stopbeing written to the physical device and the device will become read-only.Click Test to verify the space or percentage you entered.Click OK to save the configurations and return to the Storage Configuration interface, or click Cancel toreturn to the Storage Configuration interface without saving any changes. After the physical device issaved, it will be listed in the Physical Device tab.TSMIn the Create Physical Device or Edit Physical Device interface, configure the following settings:• Physical Device Name – Enter a Name for this physical device. Then type an optionalDescription for future reference.• Storage Type – Select TSM from the Storage Type drop-down list.• Storage Type Configuration – Configure the following settings:ooooooCommunication – Select the protocol to use to connect to the TSM server fromthe drop-down menu.Server address – Enter the host name or IP address of the TSM server.Server port – Enter the port to use to connect to this TSM server. The defaultport is 1500.Node name – Enter the name of the node you wish to connect to.Management class – Enter the name of the management class to manage thedata stored in the node.Node Password – Enter the password to use to connect to the node.• Advanced – Specify the following extended parameters in advanced settings ifnecessary. Note that if you have multiple parameters to enter, press Enter on thekeyboard to separate the parameters. Refer to the instructions below to addparameters.ooFileSpace – Uses a different FileSpace under the same node. The defaultFileSpace is DocAve. Note that this parameter’s value is case-sensitive. You canenter the value according to the FileSpace on your server. If the FileSpace doesnot exist, it will be created automatically.SingleSession – Uses the single session for DocAve interaction with TSM Server.• If you enter SingleSession=true, it will enable the single session forDocAve interaction with TSM Server. Note that this will slow down theperformance.114DocAve 6: Control Panel