FP-96 English Version - Eastern Federal Lands Highway Division

Section 712.) JOINT MATERIAL712.01 Sealants, Fillers, Seals, and Sleeves. Conform to the following:(a) Joint sealants and crack fillers. Furnish a commercial certificationidentifying the batch and/or lot number, material, quantity of batch, date andtime of manufacture, and the name and address of the manufacturer.(1) Concrete joint-sealer, AASHTO M 173hot-poured elastic type(2) Joint sealants, hot-poured, AASHTO M 301for concrete and asphalt pavement(3) Crack filler, hot applied, for asphalt ASTM D 5078concrete and portland cement concrete pavements(4) For proprietary asphalt-rubber products, furnish the following:(a) Source and grade of asphalt cement(b) Total granulated rubber content and mass, as percent of theasphalt-rubber mixture(c) Granulated rubber type(s) and content of each type (if blend).(1) Mass as a percent of combined rubber(2) Gradation of granulated rubber(d) Type of asphalt modifier, if any(e) Quantity of asphalt modifier and mass as a percent of asphaltcement(f) Other additives(g) Heating and application temperatures(h) Manufacturer's recommended application procedures(b) Preformed expansion joint fillers. Furnish in a single piece for thedepth and width required for the joint.(1) Performed expansion joint filler AASHTO M 33for concrete (bituminous type)(2) Performed sponge rubber expansion AASHTO M 153joint fillers for concrete paving andstructural construction710