Download - Fuji Xerox Printers

Paper Sizes/Paper Type for Trays 1 through 4Though the printer can detect the size (only standard sizes) and orientation of paper loadedin paper trays 1through 4, use the control panel to configure the size setting after loadingcustom size paper.Paper type cannot be detected and so the paper type setting also must be configured. If thepaper type setting does not match the actual type of the paper, toner may not fuse properlyto the paper, resulting in poor print quality. Make sure to configure the paper type settingscorrectly. The initial factory default setting for all the trays is plain paper.Refer to• “ Setting the Paper Sizes of Trays” (P. 129)• “ Changing the Paper Type Settings of Trays” (P. 131)Note• The printer performs image quality processing in accordance with the current paper type setting.Configuration of [Image Quality] settings on the control panel also is required when using coarse paper("coarse paper” refers to paper having conspicuous transparent characters when held up against thelight), or some types of thick paper such as business card paper. Refer to “ [Image Quality]” (P. 208) forinformation about image quality and “ Configuring Image Quality Settings for Each Paper Type” (P. 132)for information about configuring settings.Loading Paper into Tray 6 (HCF B1)When HCF B1 (optional) is installed, you can use Tray 6. The following describes theprocedure for loading paper into Tray 6.When the machine runs out of paper during printing, a message is displayed on the display.Add paper according to the displayed instructions. Printing is automatically resumed whenpaper is added.1. Pull out the tray until it stops.2. Load the paper with its print side facing upand its leading edge aligned with the leftside of the drawer.Important• Do not load paper of different types into the tray. Doingso can cause paper jams.• Do not load paper above the maximum fill line (theposition "MAX"). It may cause paper jams.126 4 Paper