Download - Fuji Xerox Printers

Print Universal Unique IDUUID is an abbreviation for Universally Unique Identifier which is an assured unique128-bitvalue. UUID printing feature prints UUIDs for each print job.The printed UUIDs can be used as a search key to retrieve print job logs using anapplication, such as the ApeosWare Accounting Service (purchase separately) orAposWare Log Management (purchase separately).Retrieving the image log with the UUID enables you to verify "when", "by whom", and "withwhat service" the document was processed. This prevents leakage of confidentialinformation.Note• For information about the Image Log Control feature, refer to “Security Feature Overview” (P. 343).1. Launch your web browser and access CentreWare Internet Services.Note• For information on how to access CentreWare Internet Services, refer to “1.6 Configuring the PrinterUsing CentreWare Internet Services” (P. 41).• If you are prompted to enter the administrator's ID and password, enter them and click [OK].2. Click the [Properties] tab.3. On the menu on the left, click [Security] > [Watermark] > [Universal Unique ID].The [Universal Unique ID] screen is displayed.4. Configure the settings.SettingPrint Universal Unique IDPrint PositionPrint Position Adjustment(Length Y)Print Position Adjustment(Width X)DescriptionSpecifies whether or not to print the UUID.• [No]• [Yes]Specifies the Universal Unique ID print position.• [Top Left], [Top Center], [Top Right], [Bottom Left], [Bottom Center],[Bottom Right].Allows fine adjustment of the UUID vertical print position in the range of0 to 100 mm.Allows fine adjustment of the UUID horizontal print position in the rangeof 0 to 200 mm.Note• With 0 mm as the edges of the paper, a larger fine adjustment valueshifts the print position more towards the center of the paper. When[Top Center] or [Bottom Center] is selected as the print position,however, the horizontal fine adjustment value for the center of thepaper is 100 mm. When [Top Center] or [Bottom Center] is selected asthe print position, first set the fine adjustment value to 100 mm andthen make fine adjustments.Print Position (Side 2)Specifies the reverse side UUID print position.• [Same as Side 1]• [Mirror Side 1]5. After all the settings are completed, click [Apply].350 7 Maintenance