Download - Fuji Xerox Printers

SettingDescriptionDNSAdded PortNumberSets whether or not to use the name registered to the DNS (Domain NameSystem) when identifying the printer.• [Enabled] (default)The DNS name is used.• [Disabled]The IP address is used.Sets the additional port number from 1 to 65535. (See *2 on P. 214.)• [80] (default)Note• Set only unique port numbers. Note, however, that InternetServices/IPP/SOAP/UPnP/WSD (See *6 on P. 214) ports and Internet services that useHTTP protocol can share the same port number.Connect Time-OutTBCP FilterSets the time after which data reception is canceled if data is not received.Specify the value from 0 to 65535 seconds in 1-second increments.• [60 Seconds] (default)Sets whether to enable or disable the TBCP filter during processing ofPostScript data.• [Disabled] (default)• [Enabled][EtherTalk Compat]Network/PortEtherTalk CompatEtherTalk CompatPort StatusEtherTalk CompatPJLSettingPort StatusDescriptionSets whether to enable or disable the EtherTalk port at printer start-up.• [Enabled]• [Disabled] (default)Important• If the printer runs out of memory when the port is enabled, the port issometimes automatically disabled. If this happens, either disable unusedports, or change the memory allocation under [Allocate Memory].PJLSets whether to enable or disable PJL commands that are sent from thecomputer.PJL commands control print jobs, and are required to print jobs using the printdriver. Use of PJL commands allows you to specify the language emulation forthe next job while another language emulation is being processed by theprinter. (See *5 on P. 214.)• [Enabled] (default)• [Disabled]154 5 Control Panel Settings