Download - Fuji Xerox Printers

MessageInsufficient fundsInsert valid cardJob has pausedUse Smart CardLoad Tray N (N: 1 to 4, 6)Symptom/Cause/RemedyPrint job has been paused due to insufficient funds. Use a valid card to continue.Note• Pressing the button will display detailed information on the controlpanel.The print job has been paused. Use a smart card to continue.Note• Pressing the button will display detailed information on the controlpanel.The tray N that contains the paper specified for printing (the size or type) is out ofpaper.Load paper into the applicable tray. This message also appears when none of theprinter's trays are loaded with the paper specified for printing (the size or type). In thiscase, change the size, orientation, or type of one of the printer's trays so it matchesthe settings shown on the display.If the message persists after the correct paper is loaded, the machine may notrecognize the paper size correctly. Make sure the position of the paper guides.Note• Pressing the button will display detailed information on the controlpanel.Refer to• “ Loading paper into Trays 1 through 4” (P. 124)• “ Loading Paper into Tray 6 (HCF B1)” (P. 126)Lower Finisher ExitCover HLower FinisherTransport Cover FNo such paper typePrint from N(N: Tray 1, Tray 2, Tray 3, Tray 4or Tray 5)Open Door G andreinsert HolePunch WasteContainer R4Open Finisher FrontDoor and addstaples to StapleCartridge R1Open Finisher FrontDoor and reinsertHole Punch WasteContainer R4Open Finisher FrontDoor and reinsertStaple Cartridge R1The Lower Finisher Exit Cover H is open.Close the cover tightly.The Lower Finisher Transport Cover F is open.Close the cover F tightly.No paper type specified by the print driver is loaded on the paper tray.Load paper indicated by the message, into the paper tray to print.The Hole Punch Waste Container is full of punch waste.Empty the Hole Punch Waste Container.Refer to• “ Emptying the Punch Waste Container” (P. 311)No staples are in the Staple Cartridge R1.Open the finisher’s front door and add the new staples to the Staple Cartridge R1.Refer to• “ Replacing Staple Cartridge” (P. 305)The Hole Punch Waste Container is full of punch waste. Take out the hole punchwaste container to discard all paper chads.Refer to• “ Replacement Procedure (for Finisher-B1)” (P. 305)• “ Replacement Procedure (for Finisher-C1 with Booklet Maker)” (P. 307)The Staple Cartridge R1 is not set properly. Open the Finisher Front Door to set thecartridge properly.Refer to• “ Emptying the Punch Waste Container” (P. 311)6.7 Error Messages and Error Codes 261